800-295-0042 ext [email protected] a few moments and read through these instructions to familiarize yourself with the step
MPG460XT800-295-0042 ext [email protected]. Wiggle the spring eyes into the front hanger brackets and bolt using 1/2” x 3” bolts an
800-295-0042 ext [email protected]. Tighten the lug fi rmly to 75 to 85 foot pounds of torque.11. Slip the large U-bolt in
MPG460XT800-295-0042 ext [email protected]. Install the wiring harness extension thru the tongue. The easiest way is to let gravi
800-295-0042 ext [email protected]:Trailer Wiring Color Code•Brown = running lights•Yellow = left turn / left brake•
MPG460XT800-295-0042 ext [email protected]. Routing the wiring harness.- Route the GREEN/BROWN wire along the RIGHT side of the fr
800-295-0042 ext [email protected]. Connecting the side lamps. To control cutting between two conductors without dam-aging
MPG460XT800-295-0042 ext [email protected]. There are holes in the back side of each lamp marked by wire color. - Identify which
800-295-0042 ext [email protected] ASSEMBLY (Group 4)1. Connect all 4 fender brackets to the fenders using 3/8” x 3/4”
MPG460XT800-295-0042 ext [email protected]. Tighten bolts fully and repeat for other side.Note that when bolting the mounting brack
800-295-0042 ext [email protected]. Installing the ground wire con-nector. Strip 3/8” of insulation off the white ground w
Bag 11491MPG460XT800-295-0042 ext [email protected] 1: Frame ComponentsBag 11462Group 2: Axle / Spring ComponentsBag 11476
MPG460XT800-295-0042 ext [email protected]. Place the skid and chain as-sembly under the tongue and insert the bolt up through the s
800-295-0042 ext [email protected] BAR ASSEMBLY (Group 6)1. Attach a load bar support tube onto the rear cross member.
MPG460XT800-295-0042 ext [email protected]. Use your hammer and carefully pound the end plugs into the ends of the support tubes.
800-295-0042 ext [email protected]. Center the load bars to the trailer, then tighten all 12 bracket bolts.7. Go back now
MPG460XT800-295-0042 ext [email protected] us at maloneautoracks.com for more fi ne products and accessories.To use the retractab
800-295-0042 ext [email protected] 4: Fender ComponentsBag 11464Group 3: Lighting ComponentsBag 11468Group 5: Coupler Com
MPG460XT800-295-0042 ext [email protected] ASSEMBLY (Group 1)1. We assemble the frame on its back to make it easier to install th
800-295-0042 ext [email protected]. Attach the spring hanger brackets to the frame. The U shaped shackle bolt brackets mount
MPG460XT800-295-0042 ext [email protected]. Install the clip nut as shown on the end of the short piece of 2x3 tub-ing. Note, the pa
800-295-0042 ext [email protected]. Bolt the tongue support to the frame rails using 3/8” x 1” carriage head bolts. Note t
MPG460XT800-295-0042 ext [email protected] AND AXLE ASSEMBLY (Group 2)2. Spin the axle to fi nd the side with the spring center
800-295-0042 ext [email protected]. Run each nut down but,ONLY UNTIL THE NUTS ALMOST TOUCH THE PLATE !!You will need lots of
Komentáře k této Příručce